35
Auto Tuner Setup
The auto tuner setup function is described on page 27 as the interactive plug-in menu. If you
need to run the auto tuner setup again, follow the steps below.
Press the M
ENU button
π†
To AUTO TUNER SETUP
è
To operate
π†
To TUNER MODE (IN ANALOG)
è
To choose CABLE, AIR or SKIP
π†
To TUNER MODE (IN DIGITAL)
è
To choose ATSC, DIGITAL CABLE or SKIP
Press the OK button to start
Programming will take approximately 2 to 4 minutes. The auto tuner is finished when the
message PROGRAMMING OVER! appears onscreen.
Press the Menu button when finished
AUTO TUNER SETUP
SELECT OPERATE EXIT
MENU
IN ANALOG
IN DIGITAL
ATSC
TUNER MODE
AIRTUNER MODE
PRESS OK TO START
Initial Setup
LCT1881-001B-A ENG e 35 5/20/05, 4:29:18 PM
To Next Page
Loading...
Need help?
General
