JVC MX-KC4 - CD Normal Playback Basics; Starting CD Playback; Selecting a CD Track

1-16 (No.MB350)
3.1.7 Removing the front panel assembly
(See Fig.24 to 27)
• Prior to performing the following procedure, remove the metal
cover, the CD fitting and the CD changer mechanism unit.
(1) Disconnect the wire from connector CN202 on the power
board.
(2) Disconnect the earth wire connected to the main base
chassis.
(3) From the bottom of the body, remove the screw N attaching
the front panel assembly.
(4) From each side of the body, remove the two screws P at-
taching the front panel assembly.
(5) Release joints g on each side of the body using a screw-
driver. Remove the front panel assembly frontward.
Fig.24
Fig.25
Fig.26
Fig.27
CN202
Rear panel
Power board
Front panel assembly
Earth wire
N
PP
g
Front panel assembly
Side panel (L)
Side panel (R)