Need help?Do you have a question about the JVC RX-318BK and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Frequency Response | 20 Hz - 20 kHz |
| Tuning range | FM, MW |
| Speaker load impedance | 8 ohms |
| Input sensitivity | 200 mV (line) |
| Signal to noise ratio | 70 dB |
| Input Sensitivity/Impedance | 2.5mV/47kOhm (phono), 200mV/47kOhm (line) |
| Power Output | 40W per channel (8 ohms, 20Hz-20kHz, 0.7% THD) |
| Inputs | 4 (Phono, Tuner, CD, Aux) |
Warning about opening the unit and user-serviceable parts, risk of shock.
Warning about exposure to rain or moisture to prevent fire or shock.
General warnings against removing covers, exposure to elements, and wet hands.
Clarifies that the power switch does not disconnect mains power completely.
Lists key features of the receiver, like monitor recording and remote control.
Explains the manual's purpose and conventions used within it.
Identifies controls on the main receiver unit, numbered 1-18.
Identifies buttons and controls on the remote control unit, numbered 1-8.
General warnings before and during installation, including handling power cords and ventilation.
Guidelines for placing the receiver, considering level surface, moisture, and temperature.
Instructions for connecting the power cord, emphasizing safe handling.
Warnings against inserting objects, disassembling, or exposing to elements.
Explains RCA connections for components like CD players and tape decks.
Instructions for connecting the turntable's ground cable to the GND terminal.
How to connect JVC audio components for remote control system.
Info on compatibility and warning against connecting Tape Deck 2.
Details about the switched AC outlets on the receiver for powering other components.
Warning about connecting components exceeding outlet capacity.
Step-by-step guide to connect up to four speakers for surround sound.
Warning to use speakers with matching impedance to the unit's terminals.
Steps to connect the supplied AM loop antenna.
Instructions for connecting an external AM antenna for better reception.
Notes on keeping the loop antenna connected and avoiding contact with uninsulated wires.
How to connect the supplied temporary FM antenna.
Instructions for connecting a 300-ohm feeder-cable antenna.
Steps to connect a 75-ohm coaxial-cable antenna.
Warning about antenna conductors touching other terminals for better reception.
Final step to plug in the power cord and indicator lights.
Warnings about handling the power cord and plugging it in.
Information on memory retention during power outages.
Instructions for inserting and replacing batteries in the remote control.
Precautions for avoiding battery leaks or damage.
A step-by-step guide to basic receiver operations like power, speakers, source, and volume.
How to select audio sources for playback on the receiver.
How the source is selected for recording and tone/volume adjustments.
Using the monitor feature to compare recorded sound quality with the source.
Notes on TAPE 2/VIDEO SOUND button function and recording from TAPE 2.
How to tune into AM and FM stations using manual and automatic tuning modes.
Advice on using manual tuning for weak stations and antenna adjustment.
How to switch between Stereo, Monaural, and Mute modes for FM reception.
Guidance on using monaural mode for noisy stereo broadcasts.
Step-by-step guide to assign channel numbers to favorite FM/AM stations.
How to use the +10 key and numeric buttons for preset channel selection.
Information about factory-set frequencies and how to overwrite them.
How to adjust master volume, use mute, and precautions.
How to select speaker sets, listen via headphones, and adjust balance.
Using BASS and TREBLE controls to adjust sound pitch and quality.
How to activate the SURROUND button for a movie theater audio experience.
How the loudness function boosts bass at low volumes for better listening.
Overview of the COMPU LINK system for controlling JVC components.
How to operate components using the receiver's remote control via the sensor.
How to set up synchronized recording from CD or turntable to tape.
How the receiver powers on/off connected components automatically.
How to operate a selected component using the remote control's source buttons.
Functions available on the remote for controlling a CD player.
Functions available on the remote for controlling a cassette deck.
How to operate a component while another is playing using CONTROL buttons.
How to operate a VCR using the remote control.
How to select and operate a CD player-changer using the remote.
A table listing common problems, their possible causes, and solutions.
Technical details for the amplifier and FM tuner sections.
Technical details for the AM tuner, general requirements, dimensions, and weight.
List of items included with the receiver.
How to find an authorized JVC service center and contact information.
Instructions on how to pack and ship the product for repair.
Warning not to service the unit yourself and to refer to qualified personnel.
How to buy accessories for the JVC product.
Explains what JVC will do, what the customer must do, and what is not covered.
Discusses limitations on implied warranties and liability for damages.
Section for recording model and serial numbers for customer reference.
To Next Page
