EasyManua.ls Logo

JVC RX-5000VBK

JVC RX-5000VBK
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
25
Specifications
Amplifier
Output Power
At Stereo operation: 100 watts per channel, min. RMS, driven
into 8 ohms, at 40 Hz to 20 kHz with no
more than 0.8 % total harmonic distortion.
At Surround operation:
Front Channel: 100 watts per channel, min. RMS, driven into
8 ohms at 1 kHz with no more than 0.8 % total
harmonic distortion.
Center channel: 100 watts, min. RMS, driven into
8 ohms at 1 kHz, with no more than 0.8 %
total harmonic distortion.
Rear channel: 50 watts per channel, min. RMS, driven into 8
ohms at 1 kHz, with no more than 0.8 % total
harmonic distortion.
Total Harmonic Distortion (8 ohms, 1 kHz):
0.8 %* at 100 watts output
(* Measured by JVC Audio Analysis System)
Audio
Audio Input Sensitivity/Impedance (1 kHz):
PHONO (MM): 2.7 mV/47 k ohms
CD, TAPE/MD, VCR, DVD:
220 mV/47 k ohms
Audio Output Level: TAPE/MD, VCR 220 mV
Signal-to-Noise Ratio (’66 IHF/’78 IHF):
PHONO: 70 dB/77 dB (at REC OUT)
CD, TAPE/MD, VCR, DVD:
87 dB/67 dB
Frequency Response (8 ohms):
PHONO: 20 Hz to 20 kHz (±1 dB)
CD, TAPE/MD, VCR, DVD:
20 Hz to 20 kHz (±1 dB)
RIAA Phono Equalization: ±1.0 dB (20 Hz to 20 kHz)
Video
Video Input Sensitivity/Impedance:
VCR, DVD: 1Vp-p/75 phms
Video Output Level:
VCR, MONITOR OUT: 1Vp-p/75 ohms
Synchronization: Negative
Signal-to-Noise Ratio: 45dB
FM tuner (IHF)
Tuning Range: 87.5 MHz to 108.0 MHz
Usable Sensitivity: Monaural: 12.8 dBf (1.20 µV/75 ohms)
50 dB Quieting Sensitivity:
Monaural: 21.3 dBf (3.2 µV/75 ohms)
Stereo: 41.3 dBf (31.5 µV/75 ohms)
Signal-to-Noise Ratio (IHF-A weighted):
Monaural: 78 dB at 85 dBf
Stereo: 73 dB at 85 dBf
Total Harmonic Distortion:
Monaural: 0.4 % at 1 kHz
Stereo: 0.6 % at 1 kHz
Stereo Separation at REC OUT: 35 dB at 1 kHz
Alternate Channel Selectivity:
45 dB: (±400 kHz)
Frequency Response:30 Hz to 15 kHz: (+0.5 dB, –3 dB)
AM tuner
Tuning Range: 530 kHz to 1,710 kHz
Usable Sensitivity: Loop antenna 400 µV/m
Signal-to-Noise Ratio: 50 dB (100 mV/m)
General
Power Requirements: AC 120V , 60 Hz
Power Consumption: 290 watts/390 VA (at operation)
2 watts (in standby mode)
Dimensions (W x H x D): 435 x 146 x 403.5 mm
(17
3
/16 x 5
3
/4 x 15
15
/16 inches)
Mass: 10.2 kg (22.5 lbs)
Designs & specifications are subject to change without notice.
EN21-25.RX-5000V[J]/F 99.11.9, 9:13 AM25

Related product manuals