EasyManuals Logo

JVC RX-6000VBK User Manual

JVC RX-6000VBK
39 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
31
English
Troubleshooting
Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact your JVC
service center.
PROBLEM
The display does not light up.
No sound from speakers.
Sound from one speaker only.
Continuous hiss or buzzing during FM
reception.
Occasional cracking noise during FM
reception.
Howling during record playing.
“OVERLOAD” starts flashing on the
display.
Remote control does not work.
SOLUTION
Plug the power cord into an AC outlet.
Check speaker wiring and reconnect if
necessary.
Press SPEAKERS 1 and 2 correctly.
Select the correct source.
Press MUTING to cancel the mute.
Check speaker wiring and reconnect if
necessary.
Adjust the balance properly (see page 11).
Connect an outdoor FM antenna or contact
your dealer.
Select a new station.
Check with your dealer to be sure you have
the correct antenna.
Check connections.
Move the antenna farther from automobile
traffic.
Move speakers away from the turntable.
1. Press POWER on the front panel to turn off
the receiver.
2. Stop the playback source.
3. Turn on
the receiver again, and adjust the
volume.
Press POWER on the front panel to turn off
the receiver, check the speaker wiring, then
press it again to turn on the receiver again.
If “OVERLOAD” does not disappear though
speaker wiring is not short-circuited, consult
your dealer.
Remove the obstruction.
Replace batteries.
POSSIBLE CAUSE
The power cord is not plugged in.
Speaker signal cables are not connected.
The SPEAKERS 1 and 2 buttons are not
set correctly.
An incorrect source is selected.
Muting is activated.
Speaker signal cables are not connected
properly.
The balance is set to one extreme.
Incoming signal is too weak.
The station is too far away.
An incorrect antenna is used.
Antennas are not connected properly.
Ignition noise from automobiles.
Your turntable is too close to speakers.
Speakers are overloaded because of high
volume.
Speakers are overloaded because of short
circuit of speaker terminals.
There is an obstruction in front of the
remote sensor on the receiver.
Batteries are weak.
EN27_33.RX-6000V[J] 99.12.14, 4:00 PM31

Other manuals for JVC RX-6000VBK

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JVC RX-6000VBK and is the answer not in the manual?

JVC RX-6000VBK Specifications

General IconGeneral
BrandJVC
ModelRX-6000VBK
CategoryReceiver
LanguageEnglish

Related product manuals