JVC RX-807VTN - Audio Component Connections; Video Component Connections

(E€EO7 “ON)
GL
Come Ove} pny exe)ar-ab em Ore dalar-yen velar . :
¢ Increasing the Rear speakers’ power output
(Rear speakers)
Surround speakers
{Front speakers) {Front speakers)
Speakers 1 Speakers 2
Turntable Center speaker
[+ SENeee CTE << |
Amplifier
AV/Tol=Yomm @xoyany eelatcyan an Oveyaretcyon diel ars
VIDEO. INPUT (VIDEO)
AV TV
To TV antenna terminal
IN (REC) OUT (PLAY)
iN (REC) |_| OUT (PLAY) (VIDEO)
IN (AUDIO)
OUT
eT coce (AUDIO) (VIDEO)
CD player Cassette deck Cassette deck {Rear speakers) a
Surround speakers
Video disc player
* Since mutual interference between video and
audio components can cause noise and distort-
ed pictures, you are recommended to use coax-
Notes: ial cable for the TV/video antenna
@ Connect speakers with the correct polarity: (+) to (+) and (—-)
to {—). Reversed polarity will degrade the stereo effect. Be care-
ful to prevent adjacent speaker wires from touching each other
@ Use speakers with the correct impedance. The correct impedance
is indicated on the rear panel of the receiver
4
1
'
’
1
1
4
1
4
1
'
i
'
'
t
t
'
1
'
‘
i
I
'
'
’
'
1
i
{
(VIDEO) (AUDIO)
IN OUT
To RF output
Speaker
Terminals
CAUTION:
VCR
Don‘t connect any equipment such as a TV with a speaker that is
already connected to this receiver
Open the speaker termi- Clamp the wire by
nat by pressing the lever resetting the lever.
and insert the stripped
end of the cord.
NLAZLO8-X¥