To Next PageTo Next PageHow to fix continuous hiss during FM reception on JVC RX-D301S?
A continuous hiss or buzzing during FM reception may occur if the incoming signal is too weak, so try connecting an outdoor FM antenna or contact your dealer. It could also be that the station is too far away; try selecting another station. Check with your dealer to ensure you have the correct antenna. Finally, ensure that the antennas are connected properly.
What to do if my JVC Receiver power does not come on?
The power cord may not be plugged in. Plug the power cord into an AC outlet.
What causes occasional cracking noise during FM reception on my JVC Receiver?
Occasional cracking noises during FM reception can be caused by ignition noise from automobiles. To resolve this, move the antenna farther from automobile traffic.
General| Channels | 5.1 |
|---|---|
| Audio Formats Supported | Dolby Digital, DTS |
| FM Tuner | Yes |
| Bluetooth | No |
| Input sensitivity | 200mV (line) |
| Signal to noise ratio | 98dB (line) |
| Tuner Type | Digital |
| Power Output | 100W per channel |
| Tuning range | 87.5 - 108.0 MHz (FM) |
| Frequency response | 10 Hz - 100 kHz |
| Total harmonic distortion | 0.08% |
| Output | Speaker, Subwoofer |
| Speaker load impedance | 6 ohms |
| Digital inputs | Coaxial, Optical |
| Video Connections | Component, Composite |
| Total Power Output | 500W |
| Outputs | Speaker, Subwoofer |
Details essential safety precautions, warnings against electrical shock, moisture, and proper handling of the unit.
Explains compliance with FCC Part 15 rules for digital devices and interference guidelines for USA users.
Outlines compliance with Canadian ICES-003 standards for digital apparatus and operational conditions.
Explains how to turn the receiver on, put it into standby mode, and the function of the standby lamp indicator.
Details selecting audio/video sources and choosing between analog or digital input modes for connected components.
Covers adjusting the main volume and temporarily turning off sound using the mute function.
Explains how to select digital audio decode modes like Dolby Digital and DTS based on the source material.
Guides users through the Quick Speaker Setup process to automatically register speaker configuration and room size.
Provides tables defining speaker sizes (L/R, C, LS/RS, SB) corresponding to channel configurations (2.0ch to 7.1ch).
Details how room size selection affects speaker distance and output levels for optimal surround sound.
Guides on setting subwoofer connection status and configuring speaker sizes (large/small) for optimal performance.
Explains how to configure surround back speakers, including selecting the number of speakers used (1SPK or 2SPK).
Details how to measure and input speaker distances for precise sound delay and localization.
Explains how to activate EX/ES/PLIIx modes for enhanced surround sound based on content type (AUTO, ON, MOVIE, MUSIC, OFF).
Assigns components (DVD, DBS, VCR, TV) to specific DIGITAL IN terminals for correct source identification.
Sets the input mode for component video sources (DVD, VCR, DBS) to ensure proper picture and system control.
Lists adjustable sound parameters including speaker levels, equalization, bass boost, and DSP effects.
Guides on adjusting individual speaker output levels for balanced sound, using a test tone for reference.
Details how to adjust output levels for all speakers to ensure a uniform listening experience, memorized per source.
Explains how to adjust the graphic equalizer in five frequency bands for the front speakers to fine-tune audio response.
Explains how the receiver uses multiple speakers to simulate the immersive sound experience of a movie theater.
Details Dolby Digital, Dolby Digital EX, and Dolby Pro Logic II (Movie/Music) surround sound modes.
Provides solutions for common power issues (no power, auto-off) and sound problems (no sound, distortion).
Offers solutions for remote control malfunctions and tuner reception problems like hiss or cracking noise.
