EasyManuals Logo

JVC RX-D702B User Manual

JVC RX-D702B
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #56 background imageLoading...
Page #56 background image
54
English
PROBLEM
Remote control does not operate as
you intend.
Remote control does not work.
Continuous hiss or buzzing during FM
reception.
Occasional cracking noise during FM
reception.
POSSIBLE CAUSE
The remote control is not ready for your
intended operation.
There is an obstruction hiding the remote
sensor on the receiver.
Batteries are weak.
The mode selector is set to the incorrect
position.
Incoming signal is too weak.
The station is too far away.
The wrong antenna is being used.
Antennas are not connected properly.
Ignition noise from automobiles.
SOLUTION
Set the mode selector correctly, then press
the corresponding source selecting button
before operation.
Remove the obstruction.
Replace batteries.
Set the mode selector to the proper
position.
Connect an outdoor FM antenna or contact
your dealer.
Select another station.
Check with your dealer to be sure you have
the correct antenna.
Check the connections.
Move the antenna farther from automobile
traffic.
Remote control
Tuner
53-55RX-D702B[C]_f.p65 05.9.14, 1:49 PM54

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JVC RX-D702B and is the answer not in the manual?

JVC RX-D702B Specifications

General IconGeneral
BrandJVC
ModelRX-D702B
CategoryReceiver
LanguageEnglish

Related product manuals