RX-DP10VBK/RX-DP10VSL
RX-DP10RSL
1-6
Prior to performing the following procedure, remove
the top cover and front panel assembly.
Disconnect the card wires and harness from
connector CN963, CN964 and CN981 on the system
control board.
Cut off the tie bands fixing the harnesses.
Disconnect the harness from connector CN43 on the
power supply 2 board and CN25 on the power/ fuse
board.
Disconnect the connector CN324 on the audio signal
2 board and CN205, CN234, CN208(J/C only) on the
audio signal 1 board.
Remove the three plastic rivet.
1.
2.
3.
4.
5.
Removing the system control board
(See Fig.5 and 6)
Prior to performing the following procedure, remove
the top cover and the rear panel.
Disconnect the connector CN631 on the DSP board.
Disconnect the connector CN203 on the audio signal
1 board.
Removing the two plastic rivet and disconnect the
connector CN633 on the DSP board.
1.
2.
3.
Removing the DSP board
(See Fig.6 and 7)
Prior to performing the following procedure, remove
the top cover and the rear panel.
Removing the screw G attaching the shield cover.
Shift the shield cover before, and pull upward.
1.
2.
Removing the shield cover (See Fig.8)
Prior to performing the following procedure, remove
the top cover.
Remove the power cord stopper from the rear panel
by moving it in the direction of the arrow.
Remove the thirty six (B/E/EN version is thirty two)
screws E attaching the each boards to the rear panel
on the back of the body.
Remove the thirteen screws F attaching the rear
panel on the back of the body and bottom.
1.
2.
3.
Removing the rear panel (See Fig.4)
Fig.5
Fig.6
Fig.8
CN324
CN963
CN981
CN971
CN977
CN983
CN964
CN985
CN25
CN234
CN205
CN208
(J/C only)
CN43
Fig.7
Shield cover
Power/ fuse
board
Power supply 2 board
Audio signal 1 board
System control board
Audio signal 2 board
Plastic rivet
Plastic rivet
CN633
CN631
Plastic rivet
Plastic rivet
DSP board
CN203
G
Tie band
Tie band
Tie band
Tie band
Tie band
To Next Page
Loading...
Need help?
General
