68
POSSIBLE CAUSE
The SCART cable is not connected
correctly.
TV input selection is incorrect.
The disc is not playable.
The unit’s and disc’s Region Code
numbers are incompatible.
Parental Lock is in use.
The disc is loaded with its label and
data sides inverted.
The unplayable disc is loaded.
The disc is scratched or dirty.
A VCR is connected between the unit
and the TV.
“STILL MODE” may not be set
appropriately for the current disc.
“MONITOR TYPE” is not set correctly.
The TV is not set correctly.
PROBLEM
No picture is displayed on the TV.
A disc cannot be played.
A disc cannot be played and “0:00” is
displayed on the display window.
Video and audio are distorted.
The picture does not fit the TV screen
properly.
No subtitle appears on the TV screen
though you have selected as your initial
subtitle language.
Audio language is different from the
one you have selected as your initial
audio language.
SOLUTION
Connect the cord correctly (see pages 9 and
10).
Select the correct input on the TV.
Replace the disc (see page 33).
Replace the disc (see page 33).
Enter your password to change the parental
level (see pages 57 and 58).
Insert the disc correctly (see page 15).
Replace the disc (see page 33).
Replace or clean the disc (see page 66).
Connect the unit and TV directly.
Select other setting of “STILL MODE” (see
page 53).
Set the monitor type correctly (see page 53).
Set the TV correctly.
Some discs are programed to always display
no subtitle initially. If this happens, press
SUBTITLE on the remote control after
starting play (see page 39).
Some discs are programed to always use the
original language initially. If this happens,
press AUDIO on the remote control after
starting play (see pages 39 and 40).
7 For DVD Player
Troubleshooting
EN61-70RX-DV3SL[B]f.pm5 02.6.6, 2:43 PM68
To Next Page
Loading...
Need help?
General
