22 EN
IN F-1
+
C
B
Basic
Playback
Features
Checking tape position
The tape position indicator
appears on the screen in the
following cases:
● When you change the VCR
operation mode from the
stop mode to fast forward
or rewind mode.
● When you perform an
Index Search ( pg. 24).
The position of “
” in relation to “B” (Beginning) or “E”
(End) shows you where you are on the tape.
NOTES:
●
“SUPERIMPOSE” must be set to “ON”, or the indicator will
not appear (
pg. 59).
●
It may take a few seconds for the tape position indicator to be
displayed.
To reset the time counter, press C. RESET on the
Remote. The counter reading becomes “0:00:00”. It is
also reset when a tape is inserted.
Playing back tape repeatedly
— Repeat Playback
You can play back a tape repeatedly (50 times).
While playing back a tape, press and hold PLAY ( 3 )
for more than 5 seconds.
The play indicator ( # ) on the front display panel starts
flashing slowly, and a tape will be played back 50 times.
To stop playback, press STOP ( 7 ) on the Remote or
STOP/EJECT ( 7
/0 ) on the front panel.
NOTE:
For a cassette recorded in D-VHS mode, Repeat Playback is not
possible if the cassette was recorded in LS3 or LS5 mode.
B
BASIC PLAYBACK AND RECORDING (cont.)
A
B E
● Turn on the VCR and the TV, and select the AV
mode on the TV.
● Set the VCR/TV/CABLE/DBS selector on the
Remote to “VCR”.
VCR
TV
CABLE
/DBS
D
C
B
VD400U-EN21-33 03.7.18, 1:03 PM22
To Next Page
Loading...
