EN 29
Watching one program while
recording another
1 Engage TV mode
During recording...
● Change the TV’s input mode from AV to TV.
2 Select channel for viewing
Select the channel you want to watch, on the TV.
Showing on-screen display
When “SUPERIMPOSE” is set to “ON” ( pg. 59), you
can see the current VCR status on the TV screen.
● For more detailed information about the on-screen
display, see page 87.
1 Display VCR status on TV screen
During recording or
recording pause, press
OSD on the Remote.
All indications
corresponding to the
current VCR status are
displayed for 5
seconds.
The time counter remains on the screen indicating
the elapsed time.
● The indications are not recorded.
2 Exit on-screen display
Press OSD again.
NOTES:
●
The subtitles does not appear while the on-screen display is
displayed.
●
If the VCR is in recording pause mode, “
¶8
” is always
displayed.
●
The VCR status can be also displayed during playback.
●
Even if “SUPERIMPOSE” is set to “OFF” (
pg. 59), the on-
screen display appears when the VCR plays back the blank
portion of a tape and the VCR receives the channel which has
no broadcast. However, on-screen display does not appear
when the input location is selected and no signal is input.
D
C
D-VHS
B E
D-VHS STD
12:00 AM
INDEX -9
CH 123HD
SAP STEREO
LR
VCR
TV
CABLE
/DBS
D
VD400U-EN21-33 03.7.18, 1:03 PM29
To Next Page
Loading...
