JVC TD-V662 User Manual

2. Installation
1) Avoid placing the unit on or adjacent to an amplifier, to prevent
hum from being produced by some types of amplifiers. Move
the unit to a place not affected by the amplifier. Keep the unit
as far as possible from a TV set.
2) Avoid installing the unit in a location subject to ambient
temperatures exceeding 40°C (104°F) (e.g. direct sunlight,
near heaters, etc.) or less than 0°C (32°F), excessive humidity,
dust or vibrations.
3) If this set is moved suddenly from a cold place (0°C) to a
warm place, it may not function properly because of moisture
generated inside the unit. The unit will function properly 30
minutes after being moved.
3. Cleaning the cabinet
Never use benzine or thinner for cabinet cleaning as they may
damage the surface finish.
4. Cassette tape
1) Loose tape may become tangled in the tape transport
mechanism. Remove slack by winding the tape with a pencil.
(Fig. 2)
4) Do not store cassette tapes where there is a magnetic field
(e.g. near a TV, etc.) or in a place subject to high temperatures
or humidity.
5. Auto tape select mechanism
This deck has an Auto Tape Select mechanism which dis
tinguishes between different types of tape from holes in the
cassette. After the type of tape has been detected, bias and
equalization are set to be suitable for the tape.
• Cassettes with the detection holes:
Metal tape (EQ: 70|is) Type IV
Cr02(chrome) tape (EQ: TOps) Type II
• Cassettes without the detection holes:
Normal tape (EQ: 120ps) Type I
Some earlier types of metal and CrOg (chrome) tapes may not
be provided with the detection holes. Avoid using such tapes,
since correct equalization characteristics cannot be obtained.
Also do not use ferrichrome tapes whose characteristics do
not match this unit.
CrQ2 tape detection holes
Metal tape detection holes
Turn the pencil to tighten the tape.
2) The use of C-120 (120 minutes turn around) or thinner tape
is not recommended, since characteristic deterioration may
occur.
3) To prevent recordings from being erased accidentally,
remove the tab (s) with a screwdriver. Reseal the slots with
adhesive tape to erase and re-record after the tabs have
been broken off.
Side "A"
6. Operations
1) When the power cord is pulled out with the deck set to the
playback or record mode, noise may be generated. Before
pulling out the power cord, confirm that the ■ (stop) button
has been pressed.
2) Many operations of this unit are performed under the control
of a microcomputer. Use the unit only after carefully studying
the descriptions and cautions in each item. If operations are
done incorrectly, the unit may stop functioning correctly. If
this happens, pull out the power cord once, and after a while
plug it in again, so that the unit can function correctly.
Tab "B" Side "B" Tab "A"
Adhesive tape

JVC TD-V662 Specifications

General

Brand	JVC
Model	TD-V662
Category	Cassette Player
Language	English