30
Advanced operations
When using the on-screen bar:
1 Press ON SCREEN twice.
The on-screen bar appears on the TV screen.
2 Press Cursor 3/2 to highlight
.
3 Press ENTER.
4 Press Cursor Y/5 repeatedly to
select “A-B”.
5 Press ENTER at the beginning of
the part you want to repeat (point
A).
6 Press ENTER at the end of the part
you want to repeat (point B).
A-B Repeat Playback starts.
7 Press ON SCREEN.
The on-screen bar disappears.
To cancel
Select “OFF” in step 4, then press ENTER.
NOTE
• When playing back a DVD VIDEO, A-B Repeat Playback is
possible only within the same title.
• “A-B” cannot be selected during Program and Random
Playback.
• “A-B” cannot be selected during playback with PBC function.
You can lock the tray and prohibit unwanted disc ejection.
On the center unit ONLY:
While the system is on standby mode, press 0, with 7
pressed and held.
• “LOCKED” appears on the display window.
• If you try to eject the disc, “LOCKED” appears to indicate
that the tray is locked.
To cancel
Carry out the same operation again.
• “UNLOCKED” appears on the display window.
You can adjust the balance between the front left and front
right speakers.
NOTE
• This function also takes effect for the sources other than
DVD.
• Before you start the operation;
There is a time limit when doing the following steps. If
the setting is cancelled before you finish, start from step 1
again.
1 Press SETTING with SHIFT
pressed.
Example:
2 Press Cursor 3/2 to make an
adjustment or selection.
Example:
The adjustment display automatically disappears a few
seconds later with the current setting.
Dolby D
2/0 . 0ch
Dolby D
2/0 . 0ch
Tray lock
Balance Setting
Press and hold
See page 20 for button locations.
THP5-P3[B]-f.book Page 30 Tuesday, December 27, 2005 3:39 PM
To Next Page
Loading...
