JVC TH-S3 User Manual

35
Tuner operations
IMPORTANT
Before using the remote control for the
following operation;
1 Set the remote control mode selector to
AUDIO.
2Press FM/AM.
Some countries space AM stations 9 kHz apart, and some countries
use 10 kHz spacing.
You can only change the AM tuner interval spacing while
tuning into an AM station.
• You can operate the following procedures using the buttons on
the front panel.
7 To change the interval spacing into 10 kHz
Press ¢ while holding down 7.
7 To change the interval spacing into 9 kHz
Press 4 while holding down 7.
NOTE
• 9 kHz is the initial setting.
1 Press FM/AM repeatedly to select the
band.
Example:
When the system is tuned in to 810 kHz.
2 Press TUNING 9/( repeatedly until
you find the frequency you want.
When you hold down the button until the system starts
searching for stations and then release it, the system stops
searching automatically when a station of sufficient signal
strength is tuned in to.
NOTE
• When a station of sufficient signal strength is tuned in, the TUNED
indicator lights on the display window.
• When an FM stereo program is received, the ST indicator lights on the
display window.
The buttons described below are used on pages 35 and
36.
Setting the AM tuner
interval spacing
AUDIO
Number buttons
Remote control
mode selector
Manual tuning
810k
TH-S3[UX].book Page 35 Wednesday, May 19, 2004 5:52 PM

JVC TH-S3 Specifications

General

Brand	JVC
Model	TH-S3
Category	Home Theater System
Language	English