(No.MB595)1-21
SECTION 5
TROUBLESHOOTING
This service manual does not describe TROUBLESHOOTING.
vi) During CHECK mode, press '6' key on REMOTE CONTROL to enter DVD x 2
JITTER MEASUREMENT MODE.
(2 seconds)
Status : AA 00 cc cc jj jj (Static)
vii) During CHECK mode, press '7' key on REMOTE CONTROL to view DVD module
EEPROM content in -1 address step.
(2 seconds)
Status : AA 00 cc cc jj jj (Static)
viii) During CHECK mode, press '8' key on REMOTE CONTROL to view DVD module
EEPROM content +1 address step.
(2 seconds)
Status : AA 00 cc cc jj jj (Static)
ix) During CHECK mode, press '9' key on REMOTE CONTROL to perform TEMPERATURE
SENSOR VALUE. (2 seconds)
Status : AA 00 cc cc jj jj (Static)
x) During CHECK mode, press '10' key on REMOTE CONTROL to perform SEARCH
DVD_DL PARALLEL DISC DESIGNATED POSITION and JITTER MEASUREMENT.
(2 seconds)
Status : AA 00 cc cc jj jj (Static)
xi) During CHECK mode, press '0' key on REMOTE CONTROL to perform monitor output.
(2 seconds)
Status : AA 00 cc cc jj jj (Static)
xii) During CHECK mode, press '+10' key to INITIALIZE DVD module EEPROM.
xiii) During CHECK mode, press PLAY key on REMOTE CONTROL to start PLAYING and
obtain LASER CURRENT and JITTER value.
(2 seconds)
Status : AA 00 cc cc jj jj (Static)
xiv) During CHECK mode, press STOP key on REMOTE CONTROL to stop JITTER measurement.
Status : AA 00 cc cc jj jj (Static)
2) During CHECK mode, at any time press MENU key to exit CHECK mode and return to starting screen of DVD
TEST MODE.
TJI X1
ccccj j j j
PEE B
W
D
ccccj j j j
PEE F
W
D
ccccj j j j
-VDDDL
ccccj j j j
IOMNTOR
TNII
ccccj j j j
ISLRJT
ccccj j j j
ccccj j j j
ETMP
ccccj j j j
To Next Page
Loading...
