10
English
Setting the Tuner Interval Spacing
You can select 10 kHz or 9 kHz apart for the AM tuner
interval spacing and 100 kHz or 50 kHz apart for the FM
tuner interval spacing.
• You need to do this setting separately for each band.
On the unit ONLY:
1
Press TUNER/BAND to select either
“FM” or “AM.”
The unit automatically turns on and tunes in to
the previously received station—either FM or AM.
• Each time you press the button, the band alternates
between FM and AM.
2
Press STANDBY/ON
while holding down 7.
• Each time you press
STANDBY/ON, the interval
spacing alternates as follows:
While selecting the AM tuner
10K (10 kHz) Ô 9K (9 kHz)
While selecting the FM tuner
100K (100 kHz) Ô 50K (50 kHz)
When you change the setting
The preset stations are erased. You will need to preset the stations
again. (See page 11.)
Listening to FM and AM Broadcasts
Tuning in to a Station
1
Press TUNER/BAND to select either
“FM” or “AM.”
The unit automatically turns on and tunes in to
the previously received station—either FM or AM.
• Each time you press the button, the band alternates
between FM and AM.
2
Press and hold ¢ or 4
(or ¡/¢ or 4/1 on
the unit) for more than 1
second.
• ¢ (¡/¢): Increases the frequencies.
• 4 (4/1): Decreases the frequencies.
The unit starts searching for stations and stops when a
station of sufficient signal strength is tuned in.
• If an FM program is broadcast in stereo, the ST (stereo)
indicator lights up on the display (only when the
reception is good).
To stop during searching, press ¢ or 4 (or ¡/¢ or
4/1 on the unit).
When you repeatedly press ¢ or 4 (or ¡/¢ or
4/1 on the unit)
The frequency changes step by step.
To change the FM reception mode
On the remote control ONLY:
When an FM stereo broadcast is hard to receive
or noisy, press REPEAT ST/MONO so that the
MONO indicator lights up on the display.
Reception will improve.
To restore the stereo effect, press REPEAT ST/MONO
again so that the MONO indicator goes off. In stereo mode,
you can hear stereo sound when a stereo program is
broadcast.
To reduce the beat—Beat Cut
On the remote control ONLY:
If the beats are heard while listening a
broadcast, press BEAT CUT.
TUNER
/BAND
REPEAT
ST/MONO
BEAT CUT
TUNER
/BAND
CD
CONTROL
STANDBY/ON
UX-H10[UW]tuner.p65 03.6.27, 1:35 PM10
To Next Page
Loading...
Need help?
General
