Introduction
17
(Continued)
Basic Operations
Press four times to display the clock, and
then adjust the clock starting from step 2 on page
16.
Press repeatedly.
NOTE
• The time display on the main unit is a 24-hour
clock.
• The clock will gain or lose approximately 1
minute per month.
• Set the clock again after you have disconnected
the power plug or a power is interrupted.
Press (or on the main unit).
• With the power off, pressing either button
also turns on the main unit.
Remote control:
Main unit:
When a disc or cassette tape has been
loaded, playback starts automatically.
Press .
NOTE
• You can also adjust the volume by turning the VOL-
UME control on the main unit.
• You can adjust the volume within the range of 0
to 40.
Press .
• Each time you press , the display
changes as follows.
• While the sound mode is set to an item other
than "FLAT", is displayed in the
display window.
NOTE
• This function does not affect recording sound.
1 Press repeatedly to display
"MANUAL".
2 For adjusting bass sound;
Press .
For adjusting treble sound;
Press .
• You can adjust the sound quality within the
range of -5 to +5.
• The display returns to the sound source dis-
play in a few seconds.
NOTE
• While the sound mode is set to an item other than
"MANUAL", "NO OPERATE" is displayed in the dis-
play window and you cannot adjust bass/treble
sound.
Turning On/Off the Main Unit
Adjusting the Volume
Adjusting the clock
Displaying the clock while using the
main unit
Adjusting the Sound Quality
Selecting the sound mode
: For emphasizing treble
and bass sounds.
: Adequate for songs
and narrations.
: For emphasizing treble
sound.
: For uplifting a feeling
of being at a live per-
formance.
: For adjusting treble and
bass sounds of your
choice (shown below).
: Cancels the sound
mode (factory setting).
Adjusting bass/treble sound
UX-QD70[UB]-03.fm Page 17 Tuesday, August 30, 2005 3:56 PM
To Next Page
Loading...
