JVC XT-G70RBK - Radio Reception and Tuning; Sound Adjustments and Playback Control; Playback Enhancement Features

(68702 ON)
lL
Receiving Radio Broadcasts
1. Press the FM or AM (MW/LW) 2. Press the TUNING/TIMER/DIMMER/CHARACTER < or
button to select the band, or press
TUNER on the Remote.
On the Unit
From the Remote
When you press the TUNER
button, the fast received station
is tuned in.
Playing CDs
1. Press the & OPEN/CLOSE button . 2. Load a CD on the tray.
, | Bre
Note: When using an 8 cm CD,
place it on the inner circle of
the tray.
Recording onto a Tape
1. Press the REC/REC MUTE 0 button 2. Start playing the source you want —
and the 0% button simultaneously. CD, radio, etc.
The LED next to them lights up and the Unit
is in recording pause.
On the Unit
a
From the Remote
Note: To record a tape with Dolby
NR | see page 24.
> button to tune in the desired stations,
When the Unit tunes in the station, The TUNED indicator lights
up on the display.
3. Press the PLAY/PAUSE b/ if button.
The CD starts playing.
To stop playing
Press the STOP/CLEAR @
button.
3. Press the ® ( or <) button, depend-
ing on which side of the tape you
want record on, to start recording.
GIy,
a
The LED onthe <€(or®) button slowly
blinks to indicate recording is now on.
To stop recording
Press the @ button.
Page 8
Common Operations
The following operations are commonly used when you play any sound source.
©
|
Two Bass
NORMAL
()
BALANCE
Page 9
Adjusting the Volume
To increase the volume, turn the VOLUME control clockwise.
To decrease the volume, turn it counterclockwise.
CAUTION: Always set the VOLUME control to MIN before starting any source
such as the radio, tape, or CD player. Ifthe VOLUME control is left turned up,
the sudden blast of sound energy can permanently damage your hearing and/
or ruin your speakers.
Adjusting the Bass Sound
You can reduce or increase the amount of bass reinforcement by adjusting the TWIN BASS
control. When set to the NORMAL position, no bass reinforcement is applied.
Adjusting the Speaker Output Balance
If the sounds you hear from the right and left speakers are unequal, you can adjust the speaker
output balance with the BALANCE control.
High-fidelity Playback
When you press the SOURCE DIRECT button, the LED on the button comes on and “DIRECT
ON” appears on the graphic equalizer display. By bypassing the sound effect circuits like SEA
programs, the path of the audio signal will be shortened, giving a higher fidelity sound.
Dimmer Function (Tuner/Amplifier)
With this function you can control the display brightness while the Unit is turned off.
Press the TUNING/TIMER/DIMMER/CHARACTER < or > button.
<: makes the display dimmer while the Unit is off.
>: makes the display brighter while the Unit is off.
Listening with Headphones
A standard pair of headphones can be connected at the PHONES jack on the front panel. Be sure
to turn down the volume before connecting or putting on headphones, as high volume can
damage both the headphones and your hearing.
When you connect the headphones, no sound comes out from the speakers.
MadOZD-LX