JVC XT-G70RBK User Manual

(6870€ ‘ON) ZL-L
Adjusting the Sound
fa
;| El
geo
You can select one of five pre-programmed SEA patterns (Preset mode) or to create your own sound patterns (Manual mode).
2
PANORAMIC
TUNER CD /SEA
—p
ROCK/A — POPS.
©
CLASSICE CARD
QO ©
Using the SEA Preset Patterns (Preset Mode)
1, Make sure that the LED next to the MANU. button on the Unit is turned off.
If it lights up (the Unit is in SEA manual mode), press the PRGM button.
2, Press the desired SEA preset button.
ROCK _ Increases both treble and bass sounds.
Us
POPS Increases the richness and fullness of the vocal sound.
ee ee eae
CLASSIC Adds depth and brilliance to the sound.
Pa oe
CAR For recording onto car stereo tapes.
SOT ont cme pur oan sree cue BR ano
H.PHONE For recording onto headphones stereo tapes.
You can also use the Remote to select the SEA preset patterns,
1. Set the TUNER/CD/PANORAMIC SEA selector to the PANORAMIC SEA position.
2. Make sure that the LED next to the MANU. button on the Unit is turned off.
ff it lights up (the Unit is in SEA manual mode), press the PRGM/MANU. button.
3. Press the desired SEA preset button.
To cancel the SEA effect, press the SEA button on the Unit or SEA ON/OFF on the Remote.
Each time you press the button, the SEA effect switches on and off repeatedly.
Page 18
Page 19
Creating Your Own SEA Patterns (Manual Mode)
1. Press the MANU. button to put the Unit into SEA manual mode.
The LED next to it lights up.
2. Press the <f or f> button fo set the frequency range to be changed.
The LED on the SEA button lights up, and the frequency range level bar on the display
blinks.
Each time you press the <f or f> button, the frequency range changes up or down.
While it is blinking you can set the frequency level.
3. Press the—-LEVEL + button to set the level, while the selected frequency range level bar
is blinking.
4. Repeat steps 2 and 3 to adjust other frequency ranges.
You can adjust 7 frequency ranges.
To fatten the SEA pattern
Press the FLAT button. The adjusted SEA pattern will be flattened so you can readjust the SEA
pattern.
Note
Although the five SEA preset patterns cannot be changed, an individual sound pattern can be
created based ona preset pattern, When you make any change to the SEA preset pattern, the Unit
automatically enters the SEA manual mode so you can modify and store the pattern you create.
To store the pattern
1, Press the MEMORY button after creating your own SEA pattern.
Your own SEA pattern blinks on the display.
2. While the SEA pattern is blinking, press the SEA preset button to select the memory
number from among A, B, C, D, or E.
To record the SEA pattern
To record sound together with a SEA pattern (either a preset or manual one), first turn on SEA
and select the desired SEA pattern. The music will be enhanced according to the pattern you
selected. SEA patterns cannot be applied to the following types of recording:
+ A song cannot be dubbed (at either normal or high speeds) with a SEA sound pattern.
* When the amplifier's SOURCE DIRECT is on, songs cannot be recorded with a SEA pattern.
*GYOLD- LX

JVC XT-G70RBK Specifications

General

Brand	JVC
Model	XT-G70RBK
Category	Stereo System
Language	English