17
Basic operations
EnglishEnglish
English
English
Basic operations
In the following description, the buttons on the remote control unit are mainly used, however, you may use the
corresponding buttons on the front panel of the unit if available.
Turning on/off the unit
Press STANDBY/ON on the remote control unit or press on the front panel.
You can turn on the unit by pressing the
3
button.Inthis
operation, the unit starts playback if the disc is set in the
disc tray.
If no disc is set, NO DISC appears on the display window.
You can turn on the unit by pressing the
0
(OPEN/CLOSE)
button on the front panel.
Inserting and removing discs
1
Press0 (OPEN/CLOSE) to open the disc tray.
2
Place the disc in the tray.
3
Press 0 (OPEN/CLOSE) located on the right of the disc tray
If you press
0
(OPEN/CLOSE) for the disc being played, the unit stops playback and opens the tray.
OPEN
/CLOSE
STANDBY/ON
PLAY
MODE
123
56
89
0
+
1010
7
4
3D
PHONIC
CANCEL
RETURN
STANDBY/ON
STANDBY
STANDBY ON
DVD/VIDEO CD/CD
PAUSEPLAYSTOP
SKIP
OPEN/CLOSE
387
0
¢4
DOLBY
D
I
G
I
T
A
L
DVD/CD PLAYER
NOTE
Even if you press the STANDBY/ON or button to turn off the unit, the unit is not disconnected from the AC power
source as long as it is connected to the wall outlet. This state is called the standby mode. In this state, the unit consumes a very
small amount of power.
NOTES
The unit can playback DVD VIDEO, Audio CD, and Video CD discs only. Do not load other disc types. For details about playable
disc types, see page 12.
When loading a disc in the tray, be sure to position the disc inside the recess. Otherwise, the disc may be damaged when the
tray is closed, and the disc may not be removed from the unit.
To Next Page
Loading...
