K40 ELECTRONICS Platinum 100 - Wake-Up Sequence and GPS Connection; Understanding the Wake-Up Sequence; GPS Connection Process

To Next Page

To Previous Page

Wake-Up Sequence

(using factory default settings)

Your K40 will be ready for use following this automatic

Wake-Up sequence:

Wake-Up Sequence – The Platinum100 will announce and

display “K40 Scan, Active”, you will then hear alerts for X, K,

Ka-Band, and laser.

Wake-Up options can be changed in the Menu, page 22.

•

Wake-Up Long: default and as described above.

•

Wake-Up Short: default display sequence and an

abbreviated audible sequence of three beeps.

•

Wake-Up Silent: a display only sequence (no audible).

GPS Connection – After locating available satellites, the

Platinum100 will announce, “GPS Connected”.

NOTE:

If you are in a location that prevents connection with GPS satellites (e.g.

parking garage), your K40 will still alert you to all radar and laser threats (laser

jamming only with optional Laser Defuser installed). Once you drive to an un-

obstructed location, the GPS will connect and you will hear, “GPS Connected”.

You’re ready to drive! – Upon completion of the wake-up

sequence, the default display will appear as follows:

Want help customizing your Platinum100?

Call a K40 Expert at 800.323.5608

Speed

Compass