FALCON X Series grade 1, Hana knobs
8400-xx-1206-33 factory combinated
8400-xx-1006 uncombinated*
3400-xx-1206-33 factory combinated
3400-xx-1006 uncombinated*
*4700-80-2006 FH tailpiece, horizontal
*3450-80-2003 Spacing Washer
Or, use Falcon TP-2, TP-4 or TP-6 with retainer TPR-1
Falcon parts are not supplied.
Section 2 - 12
Product Information
FALCON S Series grade 2, Hana knobs
8400-xx-1299-33 factory combinated
8400-xx-1099 uncombinated and use*
3400-xx-1299-33 factory combinated
3400-xx-1099 uncombinated and use*
*4700-80-2006 FH tailpiece, horizontal
*3450-80-2003 spacing washer
FALCON S Series grade 2 knobs, except Hana
8400-xx-1299-13 factory combinated
8400-xx-1099 uncombinated and use*
3
400-xx-1299-13 factory combinated
3400-xx-1099 uncombinated and use*
*4700-80-2004 FS tailpiece, horizontal
*3450-80-2003 spacing washer
“99” plug & shell
large diameter
plug requires
J or K series
bottom pins
FALCON X Series grade 1 knobs, except Hana
8400-xx-1299-12 factory combinated
8400-xx-1099 uncombinated and use*
3400-xx-1299-12 factory combinated
3400-xx-1099 uncombinated and use*
*4700-80-2003 FX tailpiece, horizontal
*3450-80-2003 spacing washer
FALCON T Series, grade 1 levers
8400-xx-1299-01 factory combinated
8400-xx-1099 uncombinated and use*
3400-xx-1299-01 factory combinated
3400-xx-1099 uncombinated and use*
*Most functions use Falcon no. 030730-001-30
*T381 inside cylinder only use Falcon no. 030730-003-30
*T571 only use Falcon no. 030730-005-30
Falcon parts are not supplied.
“99” plug & shell
large diameter
plug requires
J or K series
bottom pins
FS
FH
“99” plug & shell
large diameter
plug requires
J or K series
bottom pins
“99” plug & shell
large diameter
plug requires
J or K series
bottom pins
FX
Key-In-Knob Cylinders
Or, use Falcon tailpiece TP-3 or TP-4 with Falcon retainer TPR-1.
Or, use original Falcon tailpiece TP-2 or TP-3 with Falcon retainer TPR-1 may be used.
Or, use Falcon tailpiece TP-1, TP-3, or TP-5 with Falcon retainer TPR-1.
Falcon parts are not supplied.
*NOTE: When ordering cylinder uncombi-
nated, FH tailpiece must be requested.
*NOTE: When replacing 7-pin Falcon
cylinder, a 6-pin Falcon cylinder spacer
must be used.
FH
“06” plug & shell
To Next Page
Loading...
