Kaba Peaks Preferred - Page 27

Section 2 - 15
Product Information
MARKS 170, 190, 195 Series levers, 210 Series knobs
8400-xx-1299-01 factory combinated and use*
8400-xx-1099 uncombinated and use*
3400-xx-1299-01 factory combinated and use*
3400-xx-1099 uncombinated and use*
*Mark's tailpieces
All functions except DA, DC, S: Marks tailpiece A1903-C (C9)
Functions DA, DC, S: Marks tailpiece A1903S-C (SC9)
Marks tailpieces are not supplied.
MARKS 110, 120 Series cylindrical locks
8400-xx-1299-14 factory combinated
8400-xx-1099 uncombinated and use*
3400-xx-1299-14 factory combinated
3
400-xx-1099 uncombinated and use*
*4700-80-2001 SA/3B tailpiece, horizontal
*3450-80-2003 spacing washer
NEW Brass padlock—See Kaba 1411 padlock page 2–23
STANDARD
OMNILOCK Knob, key by-pass
8400-xx-1299-17 factory combinated
8400-xx-1099 uncombinated and use*
3400-xx-1299-17 factory combinated
3400-xx-1099 uncombinated and use*
*1590-80-2000 SD/3A tailpiece, horizontal
*3450-80-2003 spacing washer
MASTER Padlocks—see page 2–23
“99” plug & shell
large diameter
plug requires
J or K series
bottom pins
MARKS 130 Series deadlocks
8400-xx-1299-01 factory combinated and use*
8400-xx-1099 uncombinated and use*
3400-xx-1299-01 factory combinated and use*
3400-xx-1099 uncombinated and use*
*Mark's tailpieces
1
3
/8" to 1
1
/2" door: Marks tailpiece 1353-L
1
5
/8" to 1
7
/8" door: Marks tailpiece 1354-L
2" to 2
1
/4" door: Marks tailpiece 1355-L
Marks tailpieces are not supplied.
“99” plug & shell
large diameter
plug requires
J or K series
bottom pins
SD/3A
"99" plug & shell
large diameter
plug requires
J or K series
bottom pins
SA/3B
“99” plug & shell
large diameter
plug requires
J or K series
bottom pins
Key-In-Knob Cylinders