Kaba Peaks Preferred - Page 28

Section 2 - 16
Product Information
OMNILOCK Lever, key by-pass
8
400-xx-1299-18 factory combinated
8400-xx-1099 uncombinated and use*
3400-xx-1299-18 factory combinated
3400-xx-1099 uncombinated and use*
*
1590-80-2000 SD/3A tailpiece, vertical
*3450-80-2003 spacing washer
SD/3A
“99” plug & shell
large diameter
plug requires
J or K series
bottom pins
PDQ SK, SP & ST levers (U.S.A.)
8400-xx-1299-16 factory combinated
8400-xx-1099 uncombinated and use*
3400-xx-1299-16 factory combinated
3400-xx-1099 uncombinated and use*
*4700-80-2002 S/3C tailpiece, vertical
*3450-80-2003 spacing washer
S/3C
“99” plug & shell
large diameter
plug requires
J or K series
bottom pins
PDQ Imported SV grade 2 knobs using Ilco 7056
or Lori 1539 cylinders and 3A or SV tailpieces
8400-xx-1299-84 factory combinated
8400-xx-1099 uncombinated and use*
3400-xx-1299-84 factory combinated
3400-xx-1099 uncombinated and use*
*1590-80-2000 SD/3A tailpiece, horizontal
*3450-80-2003 spacing washer
*two 4700-00-4007 metal washers, tailpiece
PDQ Imported grade 1 Levers (prior to U.S.A. Spirit Levers)
8400-xx-1299-23 factory combinated
8400-xx-1099 uncombinated and use*
3400-xx-1299-23 factory combinated
3400-xx-1099 uncombinated and use*
*4700-80-2001 SA/3B tailpiece, vertical
*3450-80-2003 spacing washer
*two 4700-00-4007 metal washers, tailpiece
“99” plug & shell
large diameter
plug requires
J or K series
bottom pins
SA/3B
“99” plug & shell
large diameter
plug requires
J or K series
bottom pins
SD/3A
Key-In-Knob Cylinders