large diameter
plug requires
J or K series
bottom pins
Section 2 - 17
Product Information
SARGENT 10
+
Line levers, 2000 exit device trim
8400-xx-1295-10 factory combinated
8400-xx-1095 uncombinated and use*
3400-xx-1295-10 factory combinated
3
400-xx-1095 uncombinated and use*
*4700-00-4008 neoprene washer
*1590-80-2000 SD/3A tailpiece, vertical
*3450-80-2003 spacing washer
SD/3A
SARGENT 7, 8 & 9 Line grade 1 knobs
8400-xx-1208-08 factory combinated
8400-xx-1008 uncombinated and use*
3400-xx-1208-08 factory combinated
3400-xx-1008 uncombinated and use*
*3440-00-5108 adapter assembly
“99” plug & shell
large diameter
plug requires
J or K series
bottom pins
SARGENT 5500 Line imported grade 2 knobs
8400-xx-1299-14 factory combinated
8400-xx-1099 uncombinated and use*
3400-xx-1299-14 factory combinated
3400-xx-1099 uncombinated and use*
*4700-80-2001 SA/3B tailpiece, horizontal
*3450-80-2003 spacing washer
SARGENT 465, 485, 486 single cylinder deadlocks
8400-xx-1299-90 factory combinated
8400-xx-1099 uncombinated and use*
3400-xx-1299-90 factory combinated
3400-xx-1099 uncombinated and use*
*3450-00-2000 lost motion tailpiece
*3450-80-2004 timing washer
SARGENT 6 Line grade 2 Ball knobs
8400-xx-1210-65 factory combinated
8400-xx-1010 uncombinated and use*
3400-xx-1210-65 factory combinated
3400-xx-1010 uncombinated and use*
*4700-80-2001 SA/3B tailpiece, vertical
*3400-00-2009 spacing washer
“99” plug & shell
large diameter
plug requires
J or K series
bottom pins
SA/3B
“95” plug & shell
with small diameter
plug face
SA/3B
“06” plug & shell
Key-In-Knob Cylinders
small diameter
plug face
required
Roll pin should
protrude from this side
security
bushing
+
NOTE: 10 Line, 6500: remove
Sargent nylon or plastic spindle
bushing and place washer #4700-
00-4008 over tailpiece before
installing cylinder.
To Next Page
Loading...
