54
EN
OPERATING INSTRUCTIONS
Manual control button
Wspornik
Manual control button
AU T O /CO OL
AU T O /CO OL
(1)
(2)
Manual operation
Operating temperature
Manual switch
Przycisk obsługi
ręcznej
Mode
Temperature
Room temperature
Outdoor temperature
1.
2.
i
Suggestion: For the unit adopts an Electric Heater, when the outside ambient temperature
is below 0
O
C (32
O
F), we strongly recommend you to keep the machine plugged in order to
guarantee it running smoothly.
NOTE:
Cooling operation
Heating operation
Drying operation
0°C~50°C
(-15°C~50°C / 5°F~122°F)
(For the models with low
temperature cooling system)
(32°F~122°F)
-25°C~30°C
(-13°F~86°F)
-0°C~50°C
(32°F~122°F)
Open and lift the front panel up to an angle
until it remains fixed with a clicking sound.
For some models, please use suspension
bars to prop up the panel.
One press of the manual control switch will
lead to the forced AUTO operation. If press
the switch twice within five seconds, the unit
will operate under forced COOL operation.
Close the panel firmly to its original
position.
This switch is used for testing purposes
only. You had better not choose it.
To restore the remote controller operation,
use the remote controller directly.
CAUTION:
1
3
2
●
●
NOTE: The unit must be turned off before
operating the manual control button. If the
unit is operational, continue pressing the
manual control button until the unit is off.
17°C~32°C
(62°F~90°F)
0°C~30°C
(32°F~86°F)
10°C~32°C
(50°F~90°F)
Units are equipped with a switch to run emergency operation mode. It can be accessed by
opening the front panel. This switch is used for manual operation in case the remote controller
fails to work or maintenance necessary.
Optimum performance will be achieved within these operating temperatures.If air
conditioner is used outside of the above conditions, certain safety protection features
might come into operation and cause the unit to function abnormally.
If the air conditioner runs for a long time in cooling mode and the humidity is high(over
80%) , condensed water may drip out of the unit. Please sets the vertical air flow louver to
its maximum angle (vertically to the floor), and set HIGH fan mode.
To Next Page
Loading...
