Kaisai Pro - Advanced Remote Functions; Advanced Functions Overview

76
EN
Airborne bacteria can grow in the
moisture that condenses around heat
exchangers in the unit. With regular use,
most of this moisture is evaporated from
the unit. By pressing the SELF CLEAN
button, your unit will clean itself automa-
tically. The cleaning cycle takes 30
minutes, after which the unit will turn off
automatically. Pressing the SELF CLEAN
button mid-cycle will cancel the operation
and turn off the unit.
You can use SELF CLEAN as often as
you like.
Note: You can only activate this function
in COOL or DRY mode.
SELF CLEAN function
The TURBO function makes the unit work
extra hard to reach your present temperature
in the shortest amount of time possible.
When you press the TURBO button in
COOL mode, the unit will blow cool air
with strongest wind setting to jump-start
the cooling process.
When you press the TURBO button in
HEAT mode, for units with Electric heat
elements, the Electric Heater will activate
and jump-start the heating process.
TURBO function
How To Use The Advanced Functions
The FOLLOW ME function enables the
remote control to measure the temper-
ature at its current location. When using
AUTO, COOL, or HEAT functions,
measuring ambient temperature from
the remote control (instead of from the
indoor unit itself) will enable the air
conditioner to optimize the temperature
around you and ensure maximum comfort.
1. Press FOLLOW ME button to activate
function. The remote control will send
temperature signal to the indoor unit
every three minutes.
2. Press FOLLOW ME button again to
turn off this function.
FOLLOW ME function
SWING function
ON/OFF
TEMP
TIMER
ON
TIMER
OFF
MODE
FAN
SLEEP
TURBO
CLEAN
LED
FOLLOW
SILENCE
FP
Model: RG57A4(B)BGEF
FRESH
< >
< >
For RG57A4(B)BGEF model:
Swing < > Button
Used to stop or start vertical louver movement and
set the desired left/right air flow direction. The
vertical louver changes 6 degree in angle for each
press. If keep pushing more than 2 seconds, the
vertical louver auto swing feature is activated.
Swing Button
Used to stop or start vertical louver movement and
set the desired left/right air flow direction. The
vertical louver changes 6 degree in angle for each
press. If keep pushing more than 2 seconds, the
vertical louver auto swing feature is activated.
< >