61
EN
TROUBLESHOOTING TIPS
Malfunctions
Unit does not
start
Unit not cooling
or heating
(Cooling/heating
models only)
room very well
while air flowing
out from the air
conditioner
Cause
Power cut.
Unit may have become Unplugged.
Fuse may have blown.
Battery in Remote controller may
have been exhausted.
The time you have set with timer
is incorrect.
Wait for power to be restored.
Check that plug is securely in wall
receptacle.
Replace the fuse.
Replace the battery.
Wait or cancel timer setting.
Set temperature correctly. For
detailed method please refer to
"Using remote control" section.
Clean the air filter.
Close the doors or windows.
Clear obstructions away first, then
restart the unit.
Wait.
Inappropriate temperature setting.
Air filter is blocked.
Doors or Windows are open.
Air inlet or outlet of indoor or
outdoor unit has been blocked.
Compressor 3 minutes
protection has been activated.
If the trouble has not been corrected, please contact a local dealer or the nearest customer
service center. Be sure to inform them of the detailed malfunctions and unit model number.
Notes: Do not attempt to repair the unit yourself.
Always consult an authorized service provider.
What should be done?
Troubleshooting guide
Fuse blows frequently or circuit breaker trips
frequently.
Other objects or water fall into the air conditioner.
Terrible odors are smelled or abnormal sounds
are heard.
Trouble
OPERATION(RUN) indicator or other
indicators continue flashing
If one of the following code appears on the
display area : E0,E1,E2,E3....., P0,P1,P2,
P3...., or F0,F1,F2,F3.......
The unit may stop operation or continue
to run in a safety condition (depending
on models). Waiting for about 10 minutes,
the fault may be recovered automatically,
if not, disconnect the power and then
connect it in again. If the problem still
exists, disconnect the power and contact
the nearest customer service center.
Stop the air conditioner immediately,
disconnect the power and contact the
nearest customer service center.
To Next Page
Loading...
