58
GB
According to the chosen mode, the oven will
automatically establish the recommended
temperature and on the display appears a text
„Oven … °C“. After installation of the necessary
temperature of coocking on the display will be
lighted „Thermoprobe:.. 00°C“ for installation of
desirable temperature inside of a dish.
• Press keys 1 or 2 (
- or + ) to set the
temperature.
In 3 seconds the established parameters will be
remembered and an oven will be switched off.
If everything installed correctly, on the display
should be displayed:
- actual temperature inside of a dish,
- the established temperature inside of the dish,
- the established temperature inside of the oven.
After the end of the coocking the oven beeps.
• Press keys 1 or 2 (
- or + ) to silence a
buzzer.
If it is necessary to continue the coocking press
the key 2.
3
1
2
Important! While on the display flash an
inscription “Thermoprobe: 00°C”, the
oven waits for introduction of parameters!
Important! At continue the coocking it is
necessary to establish anew temperature
inside of a dish.
Important! Take out thermoprobe carefully
to prevent a burn.