6
EN
INSTALLATION INSTRUCTIONS
These Instructions are for the qualified technician,
as a guide to the installation, adjustment and
maintenance, according to the laws and standards
in force.
Any of these operations must always be carried
out when the appliance has been disconnected
from the electric system.
ELECTRICAL CONNECTION
Before connecting the oven or built-in cooker to
the mains power supply, make sure that:
• The supply voltage corresponds to the
specifications on the data plate on the front
of the stove or at the bottom of the hob.
• The mains supply has an efficient
grounding in compliance with all applicable
laws and regulations.
Correct grounding is a legal requirement. If the
appliance is not pre-fitted with a power cable
and/or plug, use only suitable cables and plugs
capable of handling the power specified on the
appliance's data plate and capable of resisting
heat. The power cable should never reach the
temperature 50°C at any point along its length.
If the appliance is to be connected directly to
mains terminals, fit a switch with minimum
aperture of 3 mm between the contacts. Make sure
that the switch is of sufficient capacity for the
power specified on the appliance's data plate, and
compliant with applicable regulations. The switch
must not break the yellow-green earth wire. The
outlet or switch must be easily accessible.
Attention! The manufacturer declines all
responsibility for damage or injury if the
above instructions and safety precautions
are not respected.
To Next Page
Loading...
Need help?
General
