KAKA Industrial BP-1650 User Manual

Operation Manual BP-1650
KAKA
®
Industrial
- 1 -
Specifications
Model..........................................BP-1650
Stock No. ......................................173030
Max. bending length.......... 1270mm / 50”
Max. thickness................... 1.5mm / 16Ga
Max. box depth....................... 100mm /
4”
Max. lift of beam.................. 32mm / 1
1/4”
Beam adjustment.................... 16mm 5/8”
Finger nose angle............................... 45°
Packing size...................... 168x59x82
cm
N.W./G.W. ........... 202/247 kg 444/543lbs
Unpacking
The ARBOR PRESS is shipped from the
manufacture in a carefully packed Carton
box. Thoroughly inspect the product upon
opening the package. After unpacking the
unit, carefully inspect for any damage that
may have occurred during transit.
If damage has occurred, shipping
damage claims must be filed with the
carrier and are the responsibility of the
user.
Check for completeness. Immediately
report missing parts to dealer.
Carefully open crate and unbolt brake
from shipping pallet and remove from
crate using heavy duty lifting equipment
such as an overhead crane.
Warning
The warnings, cautions and instructions
discussed in this instructions or situations
that could occur. It must be understood by
the operator that common sense and
caution are factors which cannot be built
into this product, but must be supplied by
the operator.
SAVE THIS MANUAL
You will need this manual for the safety
instruction,assembly instruction,
operating procedures, parts list, and
diagram. Write your invoice number on
the inside front cover. Put both your
manual and invoice in a safe, dry place for
future reference.

KAKA Industrial BP-1650 Specifications

General

Model	BP-1650
Category	Industrial Equipment
Bending Capacity (Mild Steel)	16 gauge
Type	Box and Pan Brake
Bending Angle	0-135 degrees
Finger Widths	2, 3, 4 inches

Summary

Specifications

Unpacking

Warning

Save This Manual

Safety

Authorized Use

Specifies who is permitted and qualified to operate the machine and its intended purpose.

Safety Notes

General cautionary points to ensure safe operation of metalworking machines.

Transport and Installation

Transport

Details on how the machine is delivered and handled during transport.

Installation

Guidelines for setting up the machine in its operating environment.

Assembly

Instructions for attaching specific components like the counterweight.

Initial Adjustments

Procedures for checking and correcting alignment after shipment.

Machine Operation

Adjustments

Adjusting for Material Thickness

How to set the hold down assembly clearance for different material thicknesses.

Finger Alignment

Steps to align the bending fingers correctly for operation.

Adjusting the Clamping Pressure

Procedure to set clamping pressure based on material thickness.

Maintenance

Lubrication

Guidelines for daily lubrication of machine parts.

Environmental Protection

Information on proper disposal and recycling of appliance components.

Parts List

Drawing

Service Record