EasyManua.ls Logo

Kampmann KaCool D 1 - Training; Personnel Requirements; Qualifi Cations

Kampmann KaCool D 1
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
KaCool D 02.02.201710
Safety
Personnel requirements
In addition, the operator is responsible for ensuring that the
unit is always in a perfect technical condition.
The following therefore applies:
The operator must ensure that the maintenance intervals
described in these instructions are observed.
Hygiene requirements The operator must observe the guidelines regarding hygiene
requirements in accordance with the standards and directives
applicable at the location in which the unit is used. These
include the following, amongst others:
Observing
the hygienic separation of fresh and waste water,
the appropriate maintenance and inspection intervals,
the guidelines for air ducts and air passages,
the speci ed lter grades.
2.4 Training
The manufacturer offers training to users. Please refer to
Chapter 1.4 "Customer Service" on page 6 for contact details.
2.5 Personnel Requirements
2.5.1 Quali cations
Only people who are expected to perform their work reliably
are allowed. People whose reactions are in uenced, for
example, by drugs, alcohol or medication are not allowed.
Quali ed electrician
A quali ed electrician is speci cally trained for the working
environment in which they operate and are familiar with the
relevant standards and regulations.
Installation personnel
The installation personnel have the technical skills and
experience as well as knowledge of the relevant provisions to
carry out the tasks assigned to them and to recognise possible
dangers themselves as a result of their training. The installation
personnel have all the necessary equipment and tools.
Caretaker/user
The caretaker/user have been trained by the manufacturer in
the tasks assigned to them and advised about possible dangers
in case of improper conduct. The caretaker/user may only carry
out tasks over and above operation of the unit in normal mode
if this is speci ed in these instructions.