Kamstrup M-Bus Master MultiPort 250D - M-Bus Repeater Input Configuration

16 Kmstrup A/S • 5512853_C1_GB_01.2017
M-Bus Mster MultiPort 250D
3.8 M-Bus Repeter Input
Kmstrup M-Bus Mster MultiPort 250D cn be used s
both mster nd repeter.
Used s mster, up to 250 meters cn be connected in
n M-Bus system.
The repeter function mkes it possible to extend the
size of the M-Bus network both s to number of meters
nd totl cble length. If one mster nd four repeters
re instlled in  network, the totl cble length cn be
extended to pprox. 14 km, nd up to 1250 meters cn be
connected.
The mster is configured s repeter by plcing the
jumper on the connector mrked Repeter. Using n
M-Bus Mster MultiPort 250D s  repeter, the M-Bus
network in front of the repeter is connected to ”M-Bus
Repeter In” on terminls 53 nd 54. The following meters
re connected to M-Bus Out on terminls 24 nd 25.
Position of mster/repeter jumper.
Setting s mster or repeter.