Kane 456 - Page 28

Page 28
MENU SUB MENU OPTIONS / COMMENTS
PRESSURE FILTER
OFF = normal response.
ON = slower (damped) response
RESOLUTION
LOW = e.g. 0.01mbar resolution.
HIGH = displays to an extra decimal place
UNITS
mbar, Pa, PSI, mmHg, hPa, InH
2
O
TIME
LET BY = Set duration of let-by test in minutes.
Default = 1 minute
STABIL’N = Set duration of stabilisation
in minutes.
Default = 1 minute
TIGHTN’S = Set duration of tightness test in
minutes. Default = 2 minute
BACK
As you scroll up or down the side LEDs illuminate to point to the active line
NOTE: To EXIT the MENU at any time simply move the rotary switch to any
position other than “Menu”. Any changes that have not been
“entered” will be ignored.
MENU SUB MENU OPTIONS / COMMENTS
SCREEN
CONTRAST Factory setting is 14
BACKLIGHT 0 to 300 secs
AUX
Enables users to customise the parameters on the
AUX display: LINE 1, LINE 2, LINE 3, LINE 4,
LINE 5, LINE 6, BACK
BACK
As you scroll up or down the side LEDs illuminate to point to the active line
NOTE: To EXIT the MENU at any time simply move the rotary switch to any
position other than “Menu”. Any changes that have not been
“entered” will be ignored.