HDBASE100ME
1
1. Introduction
1.1 Introduction to HDBASE100ME
The KanexPro HDBASE100ME is a transmitter- receiver set that enables you to routes Ultra high – definition signals up to 330 feet (100
meters). This extender also features two Ethernet ports on both the units, which can be used to connect standard network devices such
Apple TV’s, network based media players, Smart TV’s, 100Base-T routers, switches and hubs for LAN access.
Ideally used with Blu-ray players, game consoles, satellite boxes and HDMI based computers that require extension up to 330 feet
connected to an HDTV or projector. Fully compliant with HDCP, EDID and DDC channels, this extender supports resolutions up to ultra
HD 4K, 1080p & 3D.
The transmitter and receiver sets are built in to metal enclosure with sturdy finish with locking power HDMI connectors and power
suppliers which protects the unit from dis-engament or signal loss.
1.2 Features
• Extend signals up to 330 ft. (100m) on single CAT6 cable
• Integrates 2-Ethernet ports for network devices
• Supports resolutions from 1080p/60@48bit to 4K
• Supports bandwidth up to 10.2 Gbps
• HDCP, CEC and EDID compliant
• Infrared Signal Input/Output, embedded over extension
• Audio support: Dolby TrueHD & DTS Master Audio
• Uncompressed audio support such as LPCM
• RS-232 Control
• Front panel-LEDs for link activity and HDCP authentication
• Locking HDMI connectors to avoid dis-engagement & signal loss
• Locking power connector
• Aluminum case with separate mounting ears.
Note: Please use a CAT5e cable with low impedance (Shielded twisted pair will be better and should be well grounded) for good transmission effect.
1.3 Package Contents
! 1 x HDMI Pro Transmitter
! 1 x HDMI Pro Receiver
! 4 x Mounting ears (Separated from the transmitter and the receiver)
! 2 x Power adapter (DC 5V, 3A)
! 2 x IR Emitter
! 2 x IR receiver
! 2 x RS232 cable
! 8 x Screws (3*6mm)
! 1 x User manual
To Next Page
Loading...
