KANSAI SPECIAL DFB-1012PS - Machine Specifications; Needle Bar Height Adjustment

Specification
Model
1012P
1412P
1012P-SM
1412P-SM
Needle
12
12
12
12
Looper
12
12
12
12
Spreader
0
12
0
12
Thread
12
24
24
36
Service needle
DV X K25
(#18, #21)
UOx 113
(#11 --18)
DV X K25
(#18, #21)
DV x57
(#11-18)
Needle gauge
4.76 X 11 = 52.36, 6.35 x 11 = 69,85
4.76 X 11 = 52.36
Feeding mechanism
Plain
Stitch length
3.5 ~ 4 stitches/inch
8~ 14 stitches/inch
3.5~4 stitches/inch
8—14 stitches/inch
Max. speed
2,000 rpm
4,500 rpm
2,000 rpm
Needle thread
Elastic thread (U.S.A.)
#2T or #3M
Spun thread
#50^80
Elastic thread (U.S.A.)
#2T or 3M
Spun thread
#50-60
Looper thread
Spun thread
#50-60
Ornament thread
Rayon and
synthetic thread
Rayon and
synthetic thread
DFB-1412P, DFB-1412P-SM
1. Needle bar's height adjustment
Needle bar height (length of needle bar from needle
plate) of this unit is 13.3—13.5mm
Adjust as follows.
1) Turn the pully to lift the needle her to the highest
position, and loosen the screw (B) in Fig.2 fixing
needle bar.
2) Adjust needle clamp so that needles enter needle
holes when the needle bar is lowered. After adjust
ment, tighten screw (8) in Fig.2 fixing the needle
bar.
Fig. 1
0\)0 0O 0 0 0O%0
U^U UU0 UUU'^
Dimension A,, 13,3 —13.5mm
Needle plate
D
ooooop)
Screw for
holding needle bar
From the library of: Diamond Needle Corp