Need help?Do you have a question about the KANSAI SPECIAL RX9701J Series and is the answer not in the manual?
General| Brand | KANSAI SPECIAL |
|---|---|
| Model | RX9701J Series |
| Category | Sewing Machine |
| Language | English |
Select the proper needle for the fabric and thread.
Check the needle for correct scarf orientation before installing.
Refer to table for maximum and standard operating speeds.
Select motor pulley based on desired machine speed and adjust belt tension.
Install looper correctly into holder A, setting angle to 2°30' and distance to 1.1mm.
Adjust looper timing by loosening pulley screws and shifting pulley.
Ensure looper is 6mm from needle bar center at its farthest right position.
Set needle bar at top stroke, 11.3mm from needle plate to needle point.
Maintain 0-0.05mm clearance between looper and needle, adjust guard to 0.2-0.3mm.
Adjust looper orbit by moving the timing mark on eccentric A.
Set clearance between needle and looper back side to 0.1-0.2mm.
Set feed dog teeth parallel and 1.0-1.2mm above needle plate.
Center feed dog front to back without touching needle plate.
Adjust stitch length from 1.4-4.5mm using adjusting knob A or lever B.
To Next Page