Need help?Do you have a question about the KANSAI SPECIAL RX9803/UF and is the answer not in the manual?
General| Brand | KANSAI SPECIAL |
|---|---|
| Model | RX9803/UF |
| Category | Sewing Machine |
| Language | English |
Explains how to read the machine's serial number and manufacturing date details.
Details how to adjust stitch length by modifying top feed dog's movement relative to main feed dog.
Describes how to adjust front-to-back movement using optional pedal or knee switch controls.
Explains procedure for setting the correct gap between top and main feed dogs for accurate fabric feeding.
Guides on adjusting top feed dog pressure for proper stitch formation and fabric feeding.
Details how to set a 1mm clearance when the top feed dog is at its extreme rearward position.
Explains how to adjust the vertical stroke of the top feed dog to a specified length.
Describes three standard positions: Center (divided-in-half), Back (rear-fixed), and Front (front-fixed) modes.
Provides step-by-step instructions to change the top feed dog's standard position from Center to Back.
Details the procedure for switching the top feed dog's standard position from Center to Front.
Outlines the reverse procedure to change the top feed dog's standard position from Back to Center.
Explains how to revert the top feed dog's standard position from Front back to Center.
Guides on converting the top feed dog's standard position from Back mode directly to Front mode.
Provides instructions for switching the top feed dog's standard position from Front mode to Back mode.
Details how to align the top feed dog's up-and-down eccentric with the upper shaft for correct timing.
Explains how to align the top feed dog's front-to-back eccentric with the upper shaft for correct timing.
To Next Page