Kanto YU - Specifications and Notices; Technical Specifications; Notices and Compliance

11
Specications
Tweeters 1 inch Silk Dome
Woofers 4 inch Kevlar®
Nominal Impedance 4 Ohm
Amplier Type Class D
Power Output 140 Watts Peak
Input Sensitivity 560 mV
Total Harmonic Distortion < 0.25%
Crossover System 2-way
Crossover Frequency 2.0 kHz
Frequency Response 60 Hz – 20 kHz
Inputs 1 x RCA L/R
1 x Bluetooth
®
4.2 with Qualcomm aptX™
Outputs 1 x Subwoofer
Speaker Terminals Left and Right Binding Posts
Input Voltage / Frequency AC 100 V - 240 V 50 / 60 Hz (auto switching)
Standby Power Consumption < 0.5 W
Remote Included
Dimensions (each speaker) W 5.5”x H 8.7” x D 7.5” (140 x 220 x 190 mm)
Net Weight (Active) 6.2 lb (2.8 kg)
Net Weight (Passive) 5.3 lb (2.4 kg)
Gross Weight 14.6 lb (6.6 kg) (boxed pair)
NOTICE: The Bluetooth
®
word mark and logos are registered trademarks owned by Bluetooth
®
SIG, Inc. and any use of such marks by Kanto Living Inc. is under license.
NOTICE: Qualcomm aptX™ is a product of Qualcomm Technologies, Inc. and/or its subsidiaries.
Qualcomm is a trademark of Qualcomm Incorporated, registered in the United States and other
countries. aptX™ is a trademark of Qualcomm Technologies International, Ltd., registered in the
United States and other countries.
NOTICE: This appliance is labeled in accordance with European Directive
2002/96/EC concerning waste electrical and electronic equipment (WEEE). This
label indicates that this product should not be disposed of with household waste.
It should be deposited at an appropriate facility to enable recovery and recycling.