Kanto YU - Bluetooth Pairing and Operation; Pairing Procedure; Bluetooth Operation Guidelines

9
Bluetooth
®
Operation
1. We recommend keeping a maximum distance of less than 10 meters (33 ft) between the speaker and
your device. The best signal delity is within this range.
2. You can stream audio from your device to the speaker using either the player control buttons of
your device or the control buttons of the remote control (see diagram of Remote Control on page 5
of this manual – buttons #17, #18, and #19).
3. Take note of the following behavior and functionality during Bluetooth
®
operation. When you are
successfully connected, the Blue LED will be lit solid, and your device will show as connected to ‘YU
by Kanto’.
• The connection between speaker and device remains active even if input source has changed.
For instance, you can switch to the RCA input source and return to Bluetooth
®
operation
without losing signal connection and, therefore, do not need to pair with the device again.
• When the speaker is put in Standby mode or powered OFF, Bluetooth
®
connection with the
device is lost. When the speaker returns to Playback mode, the Bluetooth
®
connection between
the speaker and device is re-established. However, you may notice a choppy playback signal for
approximately 30 seconds after reconnection. It will normalize.
• While the speaker can be paired with more than one device, only one device can play and
transmit audio signal at a time.
4. The YU remote control features a Bluetooth
®
Reset button to quickly disconnect a paired device and
allow a second device to pair with the speaker (button #4 on the Remote Control diagram on page
5).
• Press Bluetooth
®
Reset button to disconnect a paired device.
• Follow the pairing instructions to pair another device.
• The same behavior and functionality apply to the second device.
Bluetooth
®
Pairing
YU features Bluetooth
®
4.2 with Qualcomm® aptX™ technology. YU can be paired with many devices for
wireless audio playback from your phone, MP3 player or tablet. Pairing is easy.
1. Press the Bluetooth
®
button ( ) on YU’s remote to select it as the input source. The Bluetooth LED
(blue) will ash to indicate that YU is in pairing mode.
2. Enable your Bluetooth
®
device to search for a new device to pair with. Select ‘YU by Kanto’ from the
list of Bluetooth devices available for pairing.
3. If pairing is successful, the Bluetooth
®
LED (blue) will remain solid. You will not need to pair the
same Bluetooth device again - ‘YU by Kanto’ will remain on your device list until the YU is paired with
a dierent Bluetooth
®
device.
4. If the device does not pair with YU, turn the speaker’s ON/OFF Switch to the OFF position. Turn the
speakers back on, then repeat steps 1 to 3. Alternatively, you can press the Bluetooth
®
reset button
( ) on the remote or turn o Bluetooth
®
on your device and turn it back on again.