CWP 2000 English
5.959-373 A 2006471 (06/03)
Operating Instructions
Position your vehicle pointing straight forward, and in the
middle between the gantry tracks.
E.5.3 After positioning
n Switch the engine OFF.
n Leave in gear, or, in the case of automatics, select “P”.
n Put the handbrake ON.
n Leave the vehicle and start the wash programme.
E.6 Programme selection and start
E.6.1 Using control unit (option)
If no wash-card reader is present, the wash programmes
are selected using the control unit (option) or the control
panel for manual functions (see Chapter C.1).
E.6.2 Using control panel for manual operation
(optional)
Press appropriate programme button (see chapter C.2).
E.6.3 Using wash card reader (optional)
Operation using a wash card reader is described in the
separate operating instructions for the wash card reader.
E.7 Wash process ended
Once the wash programme has ended, the vehicle can be
driven out of the washing unit. The positioning light
(option) indicates driving out forwards or backwards.
E.8 Taking the system out of service
E.8.1 Taking the system temporarily out of service
n Terminate current programme.
n Set master switch (17.1) to “0”.
E.8.2 Shutting down
First carry out all steps in E.8.1 and in addition
n close off water supply line
n close compressed-air supply line.
If sub-zero temperatures are expected for the period of
shut-down:
n drain all water-bearing pipes.
E Operating procedure
E3
Fig. E.5: Wash card reader
20.2
20.3
20.2
20.3
To Next Page
Loading...
