( 1 800-537-4129 page 3
You will need a standard phillips head screw driver
ASSEMBLY INSTRUCTIONS
Water Supply
(Cold Water Only)
• Water hose must be at least 3/4 inch in
diameter.
• Flow rate of water supply must not fall
below 2.5 GPM (gallons per minute).
• Flow rate can be determined by running
the water for one minute into an empty
5-gallon container.
IMPORTANT PRECAUTIONS –
continued
• The water supply temperature must not
exceed 104°F/40°C.
• Never use the pressure washer to draw in
water contaminated with solvents, e.g. paint
thinners, gasoline, oil, etc.
• Always prevent debris from being drawn into
the unit by using a clean water source.
Step4 Connect the hose
reel high pressure hose exten-
sion to the unit’s high pressure
outlet.
Step3 Attach the handle
extension to the handle, align
holes. Tighten the 2 smaller
screws.
Step1 Attach the mobile
adapter brackets to the pres-
sure washer. Align holes on
the bottom of the pressure
washer as shown and tighten
the 4 long screws.
Step2 Spread handle sides
apart and align with slotted
areas of mobile adapter brack-
ets and snap into position.
Tighten the 4 long screws.
Step5 Connect the hose
reel high pressure hose exten-
sion to the hose reel fitting.
Step6 Connect the
high
pressure hose
to the hose reel
outlet.
To Next Page
Loading...
