26 English
The cleaning ro-
bot does not start
Ambient temperature is be-
low 32 °F (0 °C) or above
95 °F (35 °C).
1. Use the cleaning robot at tem-
peratures above 32 °F (0 °C)
and below 95 °F (35 °C).
Charging state is too low. 1. Charge the cleaning robot.
Laser distance sensor (Li-
DAR) is blocked.
1. Clean the laser distance sen-
sor with a dry cloth.
2. Remove obstacles blocking
the laser distance sensor.
3. Move the cleaning robot to
another location and start it.
Collision sensor is dirty or
too close to the virtual wall.
1. Remove foreign objects by
carefully tapping on the colli-
sion sensor.
2. Move the cleaning robot to
another location and start it.
Fall sensors are dirty. 1. Clean the fall sensors with a
dry cloth.
2-in-1 dust container with
water reservoir or dust con-
tainer is not installed or in-
correctly installed.
1. Make sure that the 2-in-1 dust
container with water reservoir
or the dust container is in-
stalled and correctly latched
into place, see chapter In-
stalling the 2-in-1 dust con-
tainer with water reservoir.
Installing the dust container
Filter not installed or incor-
rectly installed.
1. Make sure that the filter is cor-
rectly installed.
Filter dirty. 1. Clean the filter, see chapter
Cleaning the filter.
2. If the error persists, replace
the filter, see chapter Replac-
ing the filter.
Wiper cloth or wiper cloth
holder not or incorrectly in-
stalled.
1. Ensure that the wiper cloth
holder and wiper cloth are
correctly installed, see chap-
ter Installing the wiper cloth
holder with wiper cloth.
The cleaning robot is
jammed or stuck.
1. Remove obstacles.
The cleaning robot or one of
its wheels has no floor con-
tact.
1. Place the cleaning robot on a
flat surface.
Error Cause Rectification