Karma S-Ergo 100 Series - Fitting Vehicle Restraints

17
without any tools.
4.1.7.2 Pull out the release lever on both side, turn it down by 90°, release it, and
make the release pin out of its position holes. (See Figure 4.19-20)
4.1.7.3 Pull up the armrest on both sides, and then move it forward or backward to
the desired position, push it down, and make the screw go into the desired
slot. (See Figure 4.21-22)
4.1.7.4 Turn the release lever to its original position, and make the release pin go
into the desired holes. (See Figure 4.23)
Figure 4.19
Figure 4.20
Figure 4.21
Figure 4.22
Figure 4.23
4.2 Transferring In and Out
4.2.1 Transferring In
4.2.1.1 Engage both hand brakes.
4.2.1.2 Turn the footplates up and swing them to the side.
4.1.2.3 The user lowers his or her body into the seat using the armrests for
support.
4.1.2.4 Turn the footplates back down, so that the user can place his feet on them.
4.1.2.5 Release both hand brakes.
CAUTION: