10
Willow Display:
The Willow nozzle (marked W on the inside of the
cone) uses the 3/8” x 4” bolt.
Model Height Width
3400JF/HJF 4.5’ 15’
4400JF/HJF 6’ 23’
Juniper Display:
The Juniper nozzle (marked with J on in inside of the
nozzle cone) uses the 3/8” x 4” bolt.
Model Height Width
3400JF/HJF 3’ 20’
4400JF/HJF 4’ 27’
Sequoia Display:
The Sequoia nozzle is not marked and uses the shorter
3/8” x 2.25”
Model Height Width
3400JF/HJF 7’ 4’
4400JF/HJF 9.5’ 6’
Nozzle Options
NOTE: Pattern sizes listed are approximate. Varia-
tions in voltage caused by regional electrical differenc-
es or voltage drop due to long power cords may result
in reduced pattern sizes.
• The Cypress is the only nozzle that uses the sepa-
rate collar labeled C2.
• The Cypress, Linden, Willow, and Juniper nozzles
use the 3/8” x 4” bolt.
• The Sequoia nozzle uses the shorter 3/8” x 2.25”
bolt.
To install, simply drop the bolt through the nozzle and
thread into the top of the cone on the fountain.
Cypress Display:
The Cypress nozzle (marked C1 on n) makes use of
the collar (marked C2 on the top rim) and the 3/8” x
4” bolt.
Model Height Width
3400JF/HJF 6’ 16’
4400JF/HJF 7.5’ 25’
Linden Display:
The Linden nozzle (marked L inside one of the ns)
uses the 3/8” x 4” bolt.
Model Height Width
3400JF/HJF 6’ 18’
4400JF/HJF 8’ 25’
To Next Page