© 2019 KCodes Corporation. All rights reserved. 6 Series User’s Manual V1.0
2. Enter “open server’s Server Name” or “open server’s IP address”. If you have changed the default
FTP port : 21 to the new value, you have to add the new port number in the tail of command as
“open server’s Server Name ftp port” or “open server’s IP address ftp port” .
3. If you set Enable Server Authentication in FTP server protocol settings you have to enter user
name and password to login to the Server; if you set Allow Anonymous Login, you can use the
user name “anonymous” to login with Read-only permission. If you clear Server authentication,
you do not need username or password to login to the Server. You can add user name and
password in User Account box the Control Center or the Server’s Web pages.
4. Perform FTP commands to use this FTP server.
To Next Page
Loading...