KCodes 6 Series - Chapter 8 Restore Factory Defaults; Restore via Web Pages; Restore via Init Button; Default Parameters List

© 2019 KCodes Corporation. All rights reserved. 6 Series User’s Manual V1.0
Chapter 8 Restore Factory Defaults
You may restore the Server’s default parameters by one of the following methods.
8.1. Using the Server’s Web Pages
1. Go to the Server’s web page and click CONFIG
2. Enter administrator (default: admin) and password (default: admin).
3. Click Maintenance.
4. Click Factory Default.
5. Click Yes to confirm
8.2. Using Init Button
Turn on server and wait until you can see it on control center, press the initial button over 10 sec. Server
will automatically shut down and restart, this process will take about 1 min, after restart server will back
to factory default.
8.3. Default Parameters List
 General Information
 Server Name: KC601 (for 601) or KC601n (for 601n) or KC604n (for 604n) or KC611 (for 611) or
KC612 (for 612) or KC612ac (for 612ac)