© 2019 KCodes Corporation. All rights reserved. 6 Series User’s Manual V1.0
Chapter 10 The Init Button
The Init button is used for maintenance: Simultaneously press Init button and turn on (by plugging in the
power adaptor) the Server until USB1 and USB2 LED indicators simultaneously blinks. (For 601/601n, only
USB LED indicator will blink.) After that, the Server will do the following tasks:
Perform a Factory Default restoration of the server, which will restore most of the
parameters and settings to factory default values.
Perform a TFTP server. You can upgrade new firmware using any TFTP client tool.
Note: After performing the tasks mentioned above, you have to plug off the power adaptor and then plug
in the power adaptor to restart the Server.
To Next Page
Loading...