7 Configuration
General information for configure devices
A Kemro automation system needs data for the configuration of system per-
formance, its I/O-devices and interfaces. The system reads this data during
the start-up operation and allocates them to its components and devices.
Configuration data is created by included configuration tools or by editing con-
figuration files.
For further information about the configuration see the documentation of the
included configuration tool.
7.1 Setting the K-Net address
The CP 263/x has no onboard K-Net. To use K-Net the option module BX 250/
A has to be used.
The addressing (Station address) of the module carried out with the address
switches which are on the top of the body.
On leaving the factory, all modules are set to address 0. Therefore the K-Net
address is setted correctly and does not have to be changed.
Fig.7-1: Position of address switches
CP 263/S, CP 263/X Configuration
© KEBA 2014
Project engineering manual V1.01 31
To Next Page
Loading...
Need help?
General
